Hydraulické čerpadlo Nachi U25-3 U25S RB511-61114 pro minibagru Kubota U25-3 U25S

1. Product Identification
Component: Main Hydraulic Variable Displacement Axial Piston Pump Assembly

Manufacturer Model Number: Nachi PVD-0B-24P-6G3-4191A (PVD Series Architecture)

Kubota OEM Part Numbers: RB511-61114, RB511-61112 (RB51161114, RB51161112)

Machine Compatibility:

Kubota U25-3

Kubota U25S Mini Excavator

Condition: Genuine Original New / Premium OEM Specification Equivalent

2. Technical Specifications
Pump Type: Variable Displacement Axial Piston Pump with Auxiliary Gear Section

System Performance: Factory-engineered displacement parameters, flow profile, and working pressure limits specifically matched to the hydraulic requirements of Kubota 2.5-ton zero-tail-swing mini excavators.

Integrated Control Network: Features integrated load-sensing control regulators to manage multi-function oil distribution and prevent engine lugging under high digging loads.

Drive Configuration: Heavy-duty input spline shaft and precision mounting flange designed to attach directly to the engine flywheel dampener.

3. Critical Installation Requirements
Hydraulic Pump Housing Priming (Mandatory)
Before starting the engine, manually fill the pump casing with fresh, clean hydraulic fluid through its highest case drain port. Operating an axial piston pump dry—even for a few seconds—will score the swash plate, valve plate, and piston slippers, causing immediate pressure loss.

Air Bleeding & Initial Startup Procedure
After mounting and filling the pump, loosen the top air bleed port on the pump housing. Crank the engine with the fuel delivery disabled until a steady stream of bubble-free hydraulic oil flows out, then retighten the plug. Allow the machine to idle at low RPM with no load for 10 to 15 minutes to purge any remaining air from the system.

Complete Hydraulic System Flushing
If replacing a pump that failed mechanically, completely drain and flush the main hydraulic fluid tank, clean circuit lines, and flush the oil cooler. Always replace return and suction filter elements prior to initial engine startup.

Pressure Regulator & Relief Valve Verification
Verify that system main relief pressures match factory Kubota specifications upon initial testing. Improper relief valve settings can cause sluggish implement speed, circuit overheating, or engine stalling under load.

4. Frequently Asked Questions (FAQ)
Q: Are part numbers RB511-61114 and RB511-61112 fully interchangeable?
A: Yes. Part number RB511-61114 is the standard factory supersession and engineering update for RB511-61112 on Kubota U25-3 and U25S models. Both cross-reference directly to the Nachi PVD-0B-24P platform and share identical physical dimensions, shaft splines, and port patterns.

Q: My Kubota U25-3 bogs down or stalls the engine when performing multi-function movements (e.g., boom lift while tracking). Is the main pump at fault?
A: Engine lugging under load usually indicates worn internal dynamic groups or sticking load-sensing pump regulators failing to destroke fluid output when pressure spikes occur. Replacing the main pump assembly restores balanced engine-to-hydraulic power delivery.

Q: Is this pump supplied as a complete assembly with the rear gear pump attached?
A: Yes. The unit arrives complete as a single integrated pump assembly, including the main axial piston pump section, factory-calibrated regulator blocks, and the auxiliary gear pump section.

5. Shipping & Logistics
Packaging: Preserved with rust-inhibiting storage oil, fitted with heavy-duty port plugs, and packed inside an export-safe protective crate or box.

Transit Time: Global express air freight via DHL/FedEx/UPS typically delivers within 3 to 7 business days directly to your workshop or job site.